Lanette
July 21st, 2004, 04:27 PM
I wanted to post this in case anyone else has issues installing DataPump v7.0. I recently received DP 7 and attempted to install it on a machine with DP 6 and Monarch Pro v7.01. I got an error message on the install telling me that Monarch Pro v7.01+ is required. I tried uninstalling everything, reinstalling Monarch Pro, then installing DP 7, but with the same results.
When I contacted tech support, I was told that DP7, for some reason, cannot find manually updated Monarch V7.01.
There is a switch to add to running the setup.exe that will bypass the check for Monarch. I was able to successfully install running the following DOS command line with the switch included:
D:DataPumpsetup.exe -InstallOnStandard
Hope this helps. I did not find this posted in the KB anywhere, so I apologize if this is duplicate information.
When I contacted tech support, I was told that DP7, for some reason, cannot find manually updated Monarch V7.01.
There is a switch to add to running the setup.exe that will bypass the check for Monarch. I was able to successfully install running the following DOS command line with the switch included:
D:DataPumpsetup.exe -InstallOnStandard
Hope this helps. I did not find this posted in the KB anywhere, so I apologize if this is duplicate information.